Skip to navigation

Mark One Firmware Update is Live: More Reliable Fiber Printing

Today we released an update for your Mark One 3D Printer which includes the new Adjust Fiber Prime Length utility.

Using this utility will improve your success rate with fiber prints because it tunes the Mark One better for fiber variations. It will mostly improve the performance of continuous carbon fiber printing, but also adds some support for Kevlar TM and fiberglass composite printing.

After you’ve updated your Mark One, take a few minutes to run the new utility and in the future, your fiber printing will be more reliable.

If your printer is not networked, instructions on how to install your update can be found here.

All of the blogs and the information contained within those blogs are copyright by Markforged, Inc. and may not be copied, modified, or adopted in any way without our written permission. Our blogs may contain our service marks or trademarks, as well as of those our affiliates. Your use of our blogs does not constitute any right or license for you to use our service marks or trademarks without our prior permission. Markforged Information provided in our blogs should not be considered professional advice. We are under no obligation to update or revise blogs based on new information, subsequent events, or otherwise.

Never miss an article

Subscribe to get new Markforged content in your inbox

Submit